With our CarPro Velvet and Denim Orange Peel Removal pads you can now remove or substantially reduce orange peel in the top layer without sanding. While removing orange peel and deep defects you are also polishing the paint rather than leaving sanding marks which reduces the steps needed afterwards.
New to Version 2:
Multiple Diameter pads available
Foam Interlayer changed from 3/8″ to 3/16″
Redesigned foam interlayer for more effective orange peel removal
Redesigned without holes for longer durability
Reduce Orange Peel and deep defects while simultaneously polishing paint
Equivalent to 2000 grit sandpaper with out the dulling of paint and sanding haze
Reduce Orange Peel without sanding
Orange peel removal without the haze generated by sanding
Polish the paint while removing the ridges of orange peel
Less dust and clean up prior to finishing polish
Attach to hook & loop backing plate on a rotary polisher for best results.
Apply a few drops to paint or pad according to your skills and preference
Work a 2′ x 2′ section or larger to keep heat down as needed but remember the larger the area the more time it will take to level orange peel and defects.
Begin working polish on low speed for a pass.
Step up speed to approximately 1100 rpm (adjust as needed)
With proper lighting observe the level of orange peel removal while you work noting precise surface contact without pressure to level ridges.
After completing each section wipe off paint with soft microfiber towel
Brush pad in direction of fibers to remove residue
Apply a couple more drops of polish for next section
Switch out pads as needed when cut has been compromised and set aside to clean by hand.
Spray cleaning solution on face of pad.
Brush with Pad cleaning brush
Rinse face of pad.
Allow to dry before next use
Note that these pads are the equivalent of 2000 grit sandpaper
Please only use these pads if you are sure the orange peel is in the upper (clear coat) and not the color coat layer
Be careful near edges and body lines or avoid completely if you are not entirely secure in your knowledge of heavy defect removal
Do not use without sufficient skill level knowledge of clear coat thickness in conjunction with a paint thickness gauge
PLEASE NOTE: THESE PADS ARE DECEPTIVE IN THEIR AGGRESSIVENESS. Use NO PRESSURE and observe the paint temperature often.
DO NOT USE WITHOUT PAINT GAUGE UNLESS YOU HAVE TAKEN RESPONSIBILITY FOR MOVING FORWARD WITHOUT ONE.
Size: 3″ Diameter
Pore Size: 80 ppi
Foam Hardness: 3kpa
Material: Denim polishing surface with hook and loop backing